線與線的連結 - 織結 Splice
線與線的連結 - 織結 Splice
織結的主要功用是連接重量線和前導線。因為會使用到針,又稱為針結。
首先,把針刺進重量線的中央,深度約及3~5毫米,然後把針穿出線外,並把線折成L型。如果用打火機等工具事先替針頭加溫,等到把針籨線裡抽出來後,便會留下一個清晰美麗的針孔。把前導線的前端和遠投線的前端斜斜地切出一個切口後插入孔內,用露出外面的線牢牢地綁起來。這個綁法就稱為指甲結。
但是,如果沒有管孖作為輔助工作,指甲結打起來會有點困難。因此這裡介紹一個不必使用管子的無管式指甲結(Nailless Nail Knot)。
特徵是前導線會穿過繩子,所以結頭、阻力都小。
另外介紹的這個無管式指甲結不需要管子。捲線的時候記得保留點空間不要纏太緊,好讓前導線的前端通過。最後只要各往左右束緊就行了。實際動手就可以發現,其實這個繩結出乎意料的簡單。
The main function of a knot is to connect the weight line and the lead line. Because a needle is used, it is also called a needle knot.
First, insert the needle into the center of the weight line, about 3-5 mm deep. Then, pull the needle out of the line and fold the line into an L-shape. If you preheat the needle with a lighter or similar tool, a clear and neat needle hole will be left after you pull the needle out of the line. Make a slant cut at the front end of both the lead line and the far end of the weight line, insert them into the hole, and secure them firmly with the exposed thread. This knot is called a nail-nail knot.
However, without a tube for assistance, a nail-nail knot can be a bit difficult to tie. Therefore, a tubeless nail-nail knot is introduced here.
The characteristic of this knot is that the lead line passes through the rope, resulting in less knot tension and resistance.
This tubeless nail-nail knot does not require a tube. When winding the line, remember to leave some space and don't wind it too tightly so that the front end of the lead line can pass through. Finally, just tighten each side to the left and right. You'll find that this knot is surprisingly simple when you actually try it.
