釣鉤連接 - 石鯛釣結
釣鉤連接 - 石鯛釣結
這個繩結就是以使用鋼絲而聞名的石鯛釣結。為了讓鋼絲和魚鉤、轉環連接,必須使用朱殊的繩結。這個繩結在熟練之前並不好打,所以一開始不要拿鋼絲纏,反而直接施轉本來要被纏的物體(釣鉤等)會比較順利。
靠這個繩結可以讓鋼絲和魚鉤、轉環直結,因此它是很早以前就已為人知的石鯛釣結。雖然主要用來和箱型轉環連接,但最近使用快速轉環別針的機率大增,所以逐漸被新型石釣結取而代之。
首先,把鋼絲穿過環,在轉環的尾部纏繞2~3圈。這時如果不牢牢壓住,鋼絲馬上因反作用力跑回原處。接著把母線從相反方向穿過轉環。等到確認兩者在轉環順利交叉後,再強力束緊兩袝鋼絲。束緊後,把線頭放在母線鋼絲上亳無空隙的纏繞4~5次,最後用鉗子等剪斷多餘的部分就完成了。
This knot is the famous rock snapper knot, known for its use of wire. To connect the wire to the hook and swivel, the Zhushu knot must be used. This knot is not easy to tie until you are skilled, so don't start by wrapping the wire around it; instead, directly twist the object to be wrapped (the hook, etc.) for a smoother connection.
This knot allows for a direct connection between the wire, hook, and swivel, making it a well-known rock snapper knot for a long time. Although primarily used for connecting to box swivels, it has gradually been replaced by newer rock snapper knots due to the increased use of quick-swivel hooks.
First, thread the wire through the swivel and wrap it around the end of the swivel 2-3 times. If you don't hold it firmly, the wire will immediately spring back due to the reaction force. Next, thread the main line through the swivel in the opposite direction. Once you've confirmed that the two wires have crossed smoothly in the swivel, tighten them firmly. After tightening, place the end of the wire on the main wire and wrap it around 4-5 times without any gaps. Finally, use pliers or similar tools to cut off the excess part to complete the process.
