線與線的連結 - 奧爾拜結 Albright Knot
線與線的連結 - 奧爾拜結 Albright Knot
誕生於美國佛羅里達洲的奧爾拜結(Albright Knot),強度上凌駕所有繩結。連接粗線和細線時,這個繩結可說是最佳選擇。
先把粗繩的前端折成U字形,接著把細線重疊在這個地方,再把細線仔細地纏繞在反折的粗線上。纏繞的時候要注意不要纏得太緊。繞了10~15圈,讓繩子的前端通過粗繩的U字形,再往左右用力束緊。雖然束緊U字形後奧爾拜結就算是完成,但如果想對繩結再做些補強,可以不要把細繩前端多餘的長度剪掉,而是用它做個小繩圈,在裡面多繞兩圈。只要一拉結頭便落在細繩的位置上,這時再完全束緊。最後,剪掉多餘的長度就大功告成了。
其實這樣的補強可說是稍嫌過火了,但如果還是有人不放心,還有另一道手續可以加強。用加熱過的金屬棒在粗繩上壓幾下,這下子就真的萬無一失了。它也會用來連接飛繩釣法中的預備線和重量線,這時就不需要補強了。
The Albright Knot, originating in Florida, USA, surpasses all other knots in strength. It's arguably the best choice for connecting thick and thin cords.
First, fold the end of the thick cord into a U-shape. Then, overlap the thin cord in this shape and carefully wrap the thin cord around the folded thick cord. Be careful not to wrap it too tightly. After 10-15 turns, let the end of the cord pass through the U-shape of the thick cord, then tighten it to the left and right. While tightening the U-shape completes the Albright Knot, for added reinforcement, instead of cutting off the excess length of the thin cord, make a small loop and wrap it around the loop a couple more times. When you pull the knot, the end should fall onto the thin cord; then tighten it completely. Finally, cut off the excess length.
This reinforcement might be considered a bit excessive, but if you're still concerned, there's another step for further strengthening. Press the heated metal rod down on the thicker line a few times, and you're all set. It's also used to connect the reserve line and weight line in fly fishing, eliminating the need for reinforcement.
