釣鉤連接 - 內掛結 (2)
釣鉤連接 - 內掛結 (2)
把線和釣鉤的軸併攏,做一個大繩圈。如果是前頁的作法,要把等一會兒不要的線繞在軸上,不過這裡的作法纏的是用來做繩圈的線。如果本線太長不方便作業,所以特地把繩圈做得大一點。
首先,以大拇指和食指按住釣鉤的腰部和繩圈的交叉部位,再把用來做繩圈的線繞在軸上。方向往鉤頸一路繞去。這樣一來,除了不必換手指固定,而且可以一口氣繞完5圈以上。等到繞好了,用中指或無名指按住終點,慢慢抽出母線束緊。
覺得束到有9分緊了,記得確認母線是否已經來釣鉤的內側,確認無誤後,再拉住兩邊的線束緊。
Bring the line and hook spool together to make a large loop. If you're using the method from the previous page, you'd wrap the line you don't need later around the spool; however, here you're using the line for the loop. Since the line is too long, making the loop larger is a good idea.
First, hold the intersection of the hook's body and the loop with your thumb and forefinger, then wrap the line for the loop around the spool. Continue wrapping towards the hook neck. This way, you don't need to switch fingers for support and can wrap more than 5 loops in one go. Once wrapped, hold the end point with your middle or ring finger and slowly pull out the main line to tighten it.
When you feel it's about 90% tight, remember to check that the main line is inside the hook. After confirming this, pull on both sides of the line to tighten it further.
