釣鉤連接 - 克維拉線的根付

釣鉤連接 - 克維拉線的根付


克維拉線裡面有芯,而外圍則有編織包圍。首先,剪一段所需的長度,抽出裡面的芯。芯只要一拉就可以很順利的抽出來。

把釣鉤的前端從釣鉤軸的一半長度的地方刺入克維拉線,等到釣鉤通過克維拉的空洞,再從尖端抽出釣鉤。讓鉤頸的部分完全被包住。

把纏繞線和釣鉤的軸並攏,以專門用來捲線軸的道具,仔細地從鉤頸纏至腰部。等到克維拉線幾乎要纏完了,將纏繞線的前端反折,折成一個繩圈,再把纏繞線放在繩圈上繞幾圈。

整個纏繞的長度大約1公分就已足夠。剪掉多餘的線後,再塗上快乾膠和重量線專用的硬化劑就完成了。也有把克維拉放在釣鉤內側,用纏繞線捲的方式。

Kevlar line has a core inside and a braided outer sheath. First, cut the desired length and remove the core. The core can be easily pulled out with a single pull.

Insert the tip of the hook into the kevlar line about halfway down the hook spool. Once the hook has passed through the kevlar's hole, pull it out from the tip, ensuring the hook neck is completely covered.

Bring the spool of line together and carefully wind it from the hook neck to the waist using a spool-type tool. When the kevlar is almost completely wound, fold the tip of the spool back into a loop, then wrap the spool around the loop several times.

The total length of the wrap should be about 1 cm. After trimming off any excess line, apply super glue and a hardener specifically for heavyline lines. Alternatively, the kevlar can be placed inside the hook and wound around the line.


Popular posts from this blog

基本繩結 - 外科醫生結 (1) Surgeon's Knot

基本繩結 - 防脫結 及 8字結 Stop Knot / Overhand Knot / Figure of Eight Knot / Titiwa

基本繩結 - 稱人結 Bowline